XY-LF8800 - Xytronic - Soldering Products / Heat Guns  

The Xytronic LF-8800 100 Watt Solder and Desoldering Station, with  internal vacuum pump.

Key Features:

• Heater/Sensor Failed Detection: If sensor circuit fails, the heater power is shut down.
  
• Temperature “Lock-Out” feature:  The temperature can be locked with a password code.
  
• ESD Safe and Spike Free circuitry: The “Zero Voltage” electronic switching design protects voltage and current sensitive components (CMOS devices, etc.) against damaging current and transient voltage spikes commonly produced by less efficient, mechanically switched stations.
  
• Delayed Suction: To eliminate the problem of solder clogging up the tip, a delayed switch feature has been incorporated for the unit that allows the pump to continue sucking for 1.5 seconds after the actuator switch is released
  
• Energy Saver Mode: If the station is left idle for 20 minutes, the energy saver feature will automatically engage, resetting the temperature to 150°C from the previous setting.
  
• Iron Working Option:  Both soldering, desoldering irons can be used at the same time.
  
• Optional SMD Tweezers: Specially designed for SMD chips, SOT, Flat pack IC’s etc. reworking.
  
• Optional Hot Air Pencil (HAP 80): Removes SMD chips and flat packs up to 25mm.
   

Ships With:

• Soldering iron with pre-loaded standard tip
• Desoldering iron with pre-loaded standard tip
• 2 iron holders
• Maintenace kit
• Rework tweezer kit
• 426DLX Fume extractor
• AC power cord and plug
• Operation manual